What is the procedure for setting the pressure of E8F2 Pressure Sensor manually?

Manual Setting

Note:Manual setting can be performed if  is selected for the pressure setting method in the initial settings.

1.Press  to enter the pressure setting mode, and  and the set ON point for OUT1 will be alternately displayed.

2.Change the ON point (for OUT1) using  and .

3.Press  to select the displayed ON point, and  and the set OFF point for OUT1 will be alternately displayed.

4.Change the OFF point (for OUT1) using  and .

5.Press  to select the displayed OFF point, and  and the set ON point for OUT2 will be alternately displayed.

6.Change the ON point (for OUT2) using  and .

7.Press  to select the displayed ON point, and  and the set OFF point for OUT2 will be alternately displayed.

8.Change the OFF point (for OUT2) using  and .

9.Press  to select the displayed OFF point, and  and the set ON point for OUT1 will be alternately displayed.

Returning to Measurement Mode

Saving the set value: Press  for approx. 2 s. (Valid for any set value display.)

Not saving the set value: Press  and  at the same time. (Valid for any set value display.)


Did this help answer your question?

thumbs up
thumbs down

Thanks for the feedback! 🙏🏽