What are the precautions for mounting Rotary Encoders?

Do not allow water drops or oil to come into contact with Rotary Encoders.

Rotary Encoders are made of precision components. Functionality may be damaged if they are dropped. Exercise sufficient caution when handling Rotary Encoders

If Rotary Encoders are to be used with reversible rotation, check Rotary Encoders' mounting direction and increment/decrement direction before mounting them.

Be sure to check the phase-Z output while mounting Encoders if matching the Encoders' phase-Z output with the origin of the equipment to be installed.

If a gear linkage is used, do not apply an excessive load to the shaft.

Use a tightening torque of 0.49 Nm maximum if Rotary Encoders are to be secured with screws.

If a coupling is to be used, mount it within the range of the following allowable values.


Did this help answer your question?

thumbs up
thumbs down

Thanks for the feedback! 🙏🏽