According to the instruction manual of LECP6, the power is separated into the control power and moto

The reason is for the customer to configure a stop circuit. 
For safety reasons, when the stop switch is activated the control power C24V supply is kept on, but the motor power M24V is shut off. 
For this reason the power supply into the controller is separated into the control power C24V and the motor power M24V to enable configuration of the stop circuit. 
Regardless of the stop circuit configuration, there is no problem in supplying the controller power supply to the control power C24V and the motor power M24V.


Did this help answer your question?

thumbs up
thumbs down

Thanks for the feedback! 🙏🏽